gone from d15b7 to d16y1 and now not reving past 3500 rpm

[alessioo]

hey guys i seem to be be having the best luck with my car.

ive swapped motors from d15b7 to d16y1 and ive hooked up vtec sol and vtec pressure and earth.

now is there any other wires i need to do like knock or dizzy.

i got a p28 btw

really need a hand. i mite be taking it to hondatec in thomastown in the morning but i dont want to get ripped.

[hmetro24]

Are you getting and code??
http://i267.photobucket.com/albums/ii320/RonJ_HCF/picture_1213.jpg
Have you checked the timing any missing tooth off?
http://img845.imageshack.us/img845/4058/dssp.jpg (http://imageshack.us/photo/my-images/845/dssp.jpg/)

Uploaded with ImageShack.us (http://imageshack.us)
Have you tried different Ecu?

[alessioo]

timing is perfect and its not throwing any codes. its running rich as f*#k can anyone help. ECU MAN ?????

[hmetro24]

Any car using Automatic ECU ? Have u tried to reset the ecu ? Your car is running in Limp mode.
Do you have enough oil ?
have you check O2 sensor ?
did you damage any sensor by mistake ?
Check for any code (http://www.ozhonda.com/forum/showthread.php?8218-DIY-CHECK-ECU-for-j00-!&highlight=car+Rev+Past)

[TheSaint]

is it a USDM ECU? i had a USDM P28 on my D15v7 and it always ran rich as hell - had to get ebay FPR to try lean it out

also - does it have launch control enabled?

im looking at doing a D16y1 headswap on my D15b7 - got any write ups on how to do the wiring?

[alessioo]

hey guys worked it out its the crank angle sensor in my dizzy. cbf with dizzys i bought it new so i wouldnt get headaches and it turned out to be fault lol. anyway hopfuly its just that. far as i know my ecu is a jdm p28 manual i got it done from ecu man so i know its spot on.

[alessioo]

hey man (thesaint) i built my motor following this build from the states. you should check it out.
http://www.d-series.org/forums/engine-building/21761-building-powerful-street-na-d16y8-z6.html.

u should check out some wreckers to see if u can find a d16y1 head and do a head swap

[TheSaint]

i already have a head lined up to do a swap - juss need info on how to wire it up lol

[alessioo]

worked it out guys thanks for the help