VTECANDY
10-07-2011, 10:56 PM
hi everyone,
here's my problem and question, i just want to know whether i can chop off a HB4 connector and wire it to a h4 loom (they are both low and high beam, i.e. twin filament)? also a hb3 connector and wire it to a factory h1 connector?
problem is: headlight assemblies from US,take diff globes to my factory h4 and h1 globes. however was thinking, since hb4 and h4 globes both have twin filaments, it should work... saves me changing the whole wiring loom and wasting 250 bucks that i spent on these headlights.
cheers
here's my problem and question, i just want to know whether i can chop off a HB4 connector and wire it to a h4 loom (they are both low and high beam, i.e. twin filament)? also a hb3 connector and wire it to a factory h1 connector?
problem is: headlight assemblies from US,take diff globes to my factory h4 and h1 globes. however was thinking, since hb4 and h4 globes both have twin filaments, it should work... saves me changing the whole wiring loom and wasting 250 bucks that i spent on these headlights.
cheers