wont go in gear - help

[ducbui91]

im having issues with putting it in gear. car starts up normally and when i tried reversing it wouldnt go in gear and also the clutch feels more firm and abit higher up than usual. also havent started car in 3 days or so. after a few goes of forcing it into gear, it drove without a problem
any advice ne1? i was told maybe no transmission fluid or clutch is gone
cheers

[vyets]

Check clutch fluid

[AusS2000]

Yup, sounds like clutch drag.

Can be low fluid of air in your lines.

[phatty]

Or clutch master cylinder, could be a leak somewhere..

[ducbui91]

Thanks I'll get back to u guys soon

[VeYzZii]

Or clutch master cylinder, could be a leak somewhere..

If its the cylinder, the clutch would engage lower on the pedal then normal, or go straight to the floor. Try pumping the clutch a few times before putting into a gear. If the gear then goes in it can be a leak or air in the lines.

[phatty]

If its the cylinder, the clutch would engage lower on the pedal then normal, or go straight to the floor. Try pumping the clutch a few times before putting into a gear. If the gear then goes in it can be a leak or air in the lines.

Oh yeah true.. Would be easier to push in too. Yeah I'd try pumping the clutch before it goes into gear. Should go into gear fine if you pump it

[ducbui91]

all works now cheers for advice was low in fluid and bleeded
cheers

[ducbui91]

quick advice . could there be air in my cylinder coz my friction point is very high and theres no slack in the clutch