Taking off crank pulley

[V73C]

Hey guys, im gonna attempt taking of my crank pulley, whats the best way of doing it ? I dont have any access to an air tool, and dunno if a breaker bar is enough. Ive just recently put the engine in, and im not keen to pull it out again just to take it off.

Thanks guys

[riruiz_88]

im pretty sure you can hire 240V (mains power) rattle guns from kennards, coates hire. then get an impact safe bit , then happy days.

[V73C]

i guess thats the only way ? i just gave it a go, it just kept spinning :(

[jdm18c]

hey you in syd if you are come past i got air compressor and rattle gun to get it off

[TheSaint]

have a look on youtube - there are several methods
- breaker bar + leverage (using your own strength)
- breaker bar + jack (let the jack down with the breaker bar in place so that the weight of the car loosens the bolt)
- breaker bar + starter motor (brace the breaker bar and crank the engine without the ignition connected)

http://www.youtube.com/watch?v=2Zu5g95gpqo

http://www.youtube.com/watch?v=7CridrQKj3E

[V73C]

Nah jdm18c im in qld :(

Thanks heaps saint, ill give them a shot

[Lukey]

just remember shocking the bolt will crack it rather than brute strength

[V73C]

just remember shocking the bolt will crack it rather than brute strength

Yeah Ive learnt that from taking hub nuts off