CU2 Steering pull

[j0nii]

Hi Guys,

I have 2009 cu2. I've recently changed my 2 front tyres, gotten a wheel allignment and wheel balance done, but the issue is that when i place my steering straight my car still pulls to the right.
Any ideas on what could be causing this?

Thanks
Jonny

[MR_LATE]

crown of the road? who did the wheel alignment?

[j0nii]

i did my wheel allignment with highway tyres in vic richmond

[MR_LATE]

was the pull there before u changed tyres?

[buddah51au]

Swap the Tyres from left to right, if it pulls the opposite way put the offending tyre on the rear. It can happen with tyres.

[j0nii]

I don't know if the pull was there before the tyres was changed because we got 2 new tyres when we bought the car. It's my dads car and he tested it.

buddah51au: I shall try that over the weekend. Thanks. will update you guys when I've tried it

[MR_LATE]

buddah is a god,

[buddah51au]

buddah is a god,


Not even close mate, that has been a known problem with tyres for decades. Technically it is supposed to be caused by the belts being fractionally off center that causes the problem, but the tryes themselve are fine. The little knowledge I have comes from many years in the industry.