Rocker cover problem

[dc2screama]

Tryed taking off the four nuts on each corner of my rocker cover and as I went to losen one of the nuts, it just broke of and now some of the thread is in the nut and can't take it out and even if I find another nut for it there's not enough thread to screw it on. Plus when I turned on the car it was blowing the air from where the nut is,what to do peepz? Help!
It's a teg b18c btw, Thanks.

[hmetro24]

Take the rocker cover off, and take the broken bolt out, Replace it and you should be allright

[dc2screama]

So I gotta get a new bolt setup for when I take the old one out? And then just swap it

[hmetro24]

yes that's it, do not over tight these bolts.

[Lukey]

is it a nut or bolt?

[EKVTIR-T]

Yes you can get a new one from Honda
I think theyre only about 10nm.. so go easy and tighten from the middle ones outwards
And don't worry,millions have snapped them not only you

[dc2screama]

If I take the cover off don't I have to put some silicone sealant on, or will it be good without it?

[EKVTIR-T]

No just use the rubber gasket thats on there already and make sure it seats properly as you sit the cover back on

[dc2screama]

Alright thanks alot champ il take it out tomorrow, and get the part for it.
Thanks again for your help