Sway bar endlinks for Skunk2 LCA

[thatvinceguy]

Hi all,

Noob here. I have an EK1 with ASR subframe and Ek9 sway bar installed.
Recently bought Skunk2 rear LCA's. And when installed I noticed that the endlinks did not quite fit the LCAs.

The endlinks screw nicely into the threaded holes on the LCA, but the problem is that the threaded part of the endlinks are not long enough to go all the way through the LCA for nuts to be secured on.

Just wondering if this is a huge problem or not. If so, how should I go about fixing the problem?

Any help is appreciated. Thanks!

[JamesEK1]

Sorry to resurect old post.

Anyone know about this?

[mocchi]

i would use stock ek lca instead.
dont see the point of skunk2 lca.

[Snoop_gee]

As for bolts not quiet going all the way thru.
I had a a very similar experience very recently.

Running Fuction 7 rear LCA's and the ASR rear subframe brace also.
When it comes to using the ASR rear subframe brace and the bits and pieces it comes with they assume that your using stock rear control arms and things.

I had to take the original bolt and go to specialised places like aka BOLT BOYS or other places that specialise in hi tensil bolts.
I did try repco and super cheap but they didnt have 70mm + M8 bolts and was gonna take longer just to order 1 in.

http://www.crxaustralia.com/Jons/wl_629.JPG

http://www.crxaustralia.com/Jons/wl_647.JPG

http://www.crxaustralia.com/Jons/wl_636.JPG