thatvinceguy
10-10-2011, 04:53 PM
Hi all,
Noob here. I have an EK1 with ASR subframe and Ek9 sway bar installed.
Recently bought Skunk2 rear LCA's. And when installed I noticed that the endlinks did not quite fit the LCAs.
The endlinks screw nicely into the threaded holes on the LCA, but the problem is that the threaded part of the endlinks are not long enough to go all the way through the LCA for nuts to be secured on.
Just wondering if this is a huge problem or not. If so, how should I go about fixing the problem?
Any help is appreciated. Thanks!
Noob here. I have an EK1 with ASR subframe and Ek9 sway bar installed.
Recently bought Skunk2 rear LCA's. And when installed I noticed that the endlinks did not quite fit the LCAs.
The endlinks screw nicely into the threaded holes on the LCA, but the problem is that the threaded part of the endlinks are not long enough to go all the way through the LCA for nuts to be secured on.
Just wondering if this is a huge problem or not. If so, how should I go about fixing the problem?
Any help is appreciated. Thanks!