Delsol K20 swap, need to find tachometer wire

[GSi_PSi]

hey guys im just wondering where abouts i would look in the engine bay harness
to source the tachometer wire, ive searched up for normal delsol and it says its a
blue wire coming out the dizzy , obviously my engine is different, any idea were i
could find this wire?. I dont want to grab it from the cluster as i heard it wont give
the correct reading.

[GSi_PSi]

will rep +4 points to any help given

[hmetro24]

http://www.hondata.com/images/k20awiring.gif
Just go the ecu and track the wire. If you do not know which wire is it.

This PDF is usefull (http://www.google.com.au/url?sa=t&rct=j&q=k20%20tacho%20wiring&source=web&cd=9&ved=0CGEQFjAI&url=http%3A%2F%2Fwww.gizzmoelectronics.com%2Fpdf%2 FTachRecall%2520Shiftlight%2520Instruction%2520Ver 1.04.pdf&ei=M6bgTrXJN-mTiQfC8pmnBQ&usg=AFQjCNFYdMCZfV0KHECUKR7_JrElc6X55w&cad=rja)

[VTec1987]

http://b16a2.kicks-ass.net/diy/pgmfi/ecu/PGMFI-pins1-2.jpg
Look at obd1 table
You might be able to use your factory obd1 plugs to use for tacho
Pin A22

[GSi_PSi]

cheers guys, btw its to install the redline shift beeper not a rice tachometer lol

[hmetro24]

I think Ecu-man should help you with that.

[GSi_PSi]

It seems pretty simple its only the tacho wire i needed. just 3 wires, power,ground and tacho lol..

vtec-1987 i tried to rep you but need to spread rape around

[hmetro24]

It seems pretty simple its only the tacho wire i needed. just 3 wires, power,ground and tacho lol..

vtec-1987 i tried to rep you but need to spread rape around
Just go to the ECU find the tach pin and do it.

[mocchi]

so this is solved right?

ground, 12v power and tap E26 on ecu.
what ecu you have btw? prc/prb pnd?
not sure if theyre the same pinout.

[VTec1987]

It seems pretty simple its only the tacho wire i needed. just 3 wires, power,ground and tacho lol..

vtec-1987 i tried to rep you but need to spread rape around

All good champ...

[GSi_PSi]

Hey guys I wedged a wire into the plug to the blue pin e26 , it's not working :(
I've got a prd Jdm k20a ep3r ecu, should I cut and tap into the line .... Don't really wanna chop my loom unless it's the right wire 100%z

[hmetro24]

Hey guys I wedged a wire into the plug to the blue pin e26 , it's not working :(
I've got a prd Jdm k20a ep3r ecu, should I cut and tap into the line .... Don't really wanna chop my loom unless it's the right wire 100%z
ECU PIN OUT (http://www.k20a.org/forum/showthread.php?t=230)

[GSi_PSi]

Hey bud that's the one I used it's not working .

[mocchi]

did you check multimeter for the 12v power? is it the right wire?

[GSi_PSi]

for power yes its working as im using the same wire for my fan switch...