Hondata s300 - Full throttle shift With clutch switch

[Sexc86]

Hey guys,

Searched High and low but cannot seem to find any solutions. Currently running a p28 hondata and in the process of setting up full throttle shift.

Installed a clutch switch and want to run it to the B5 ACS pinout. Now how is this thing wired? Does the switch recieve a hard 12v only to be grounded by the B5 ecu pin? or is it fed a 5v signal from the B5 pin and earthed to a common ground after the switch?

cheers !

[ECU-MAN]

use B8 PSP and have the switch only ground when you press the clutch switch

[Sexc86]

Can you use this method if your still retain power steering?

[ECU-MAN]

yes

you dont really need the power steering pressure switch, its just there to allow the ECU to detect power streeing pressure in the line to ramp up engine RPM at idle.

Your car probably doesnt have a PSP Switch either.