View Full Version : clicking noise when taking off
ducbui91
11-01-2012, 04:21 PM
I get a clicking noise (one click) at the rear when I take off. Usually happens when on an uphill start. Any ideas what it could be? cv joints worn? suspension?
Cheers
I had a bit of surface rust on one of my driveshafts, cleaned it up and noise was gone.
drsilliez
12-01-2012, 12:20 AM
did not the s2000 have a rear axle nut that was not tight enough from factory which caused the click? all you have to do is tighten it......its on s2ki somewhere...
http://www.s2ki.com/s2000/topic/880667-clunk-when-disengaging-clutch-moving-slowly/ --- read the thread, ignore the thread title...i think there has been a few of these threads on s2ki
btw i have the same click you described .....
drsilliez
12-01-2012, 12:23 AM
http://www.s2ki.com/s2000/topic/681492-common-s2000-problemssolutions-1999-2009/
Problem: Clicking noise from rear when moving in first gear or reverse. Sounds like two metal marbles.
Solution: Honda use to torque the axle nuts to 180 lbs. The correct torque is now 230 lbs. Torque your axle nuts.
ducbui91
13-01-2012, 03:21 AM
cheers ill give that a go. have u fixed the problem?
ducbui91
24-01-2012, 11:14 PM
did a major service and told him to tighten the axel nut. this time theres less sound of a click. would u suggest he didnt tighten it enough?
cheers
OMG.JAI xD
26-01-2012, 09:45 AM
you probably need to replace the motor Duc common issue on the s2k lmao
Nismo3oi
26-01-2012, 10:45 AM
I have had the same problem before, just swap the axel nuts from one side to the other.
ducbui91
26-01-2012, 11:25 AM
you probably need to replace the motor Duc common issue on the s2k lmao
cars in tip top condition and is ready to be thrashed lolz
I have had the same problem before, just swap the axel nuts from one side to the other.
ill give that a shot n let u know
cheers
aozora
26-01-2012, 07:25 PM
cars in tip top condition and is ready to be thrashed lolz
ill give that a shot n let u know
cheers
No point swapping the axle nuts - ensure they are tightened to 220ft/lb. Your mechanic will need a tanky torque wrench though and ensure they are greased properly before doing so.
If he has done that, check that all suspension bolts are tightened properly.
beanz
26-01-2012, 10:12 PM
I had a similar click, cured instantly with a diff oil change. Might be worth a try.
JamieP
09-02-2012, 11:08 AM
Ive always had that same noise too. will have to try this and see what happens
ducbui91
24-03-2012, 11:44 AM
problem solved tighten axel nut
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.