Do the US GS-R Parts fit the AUS VTI-R integra

[skeptic_]

Hey i need clarification and closure as i've seen everyone ask this but no definite or precise answer. Here is the question one last time.

can parts on an Integra USDM GSR fit into the AUSDM Integra VTI-R ?

Regarding intake manifolds, header Throttle Body and Engine etc.

[trism]

There is no precise answer. Some will, some wont. As the steering rack, brake booster/master cyl, clutch master cyl, accel cable are all on the opposite side, a lot of things will not fit without some modification.

[Bludger]

There is no precise answer. Some will, some wont. As the steering rack, brake booster/master cyl, clutch master cyl, accel cable are all on the opposite side, a lot of things will not fit without some modification.
baws answer right dher

[IV73CI]

There is no precise answer. Some will, some wont. As the steering rack, brake booster/master cyl, clutch master cyl, accel cable are all on the opposite side, a lot of things will not fit without some modification.

Like a boss..

[dc2r-0636]

Anything in particular you wanted clarification on ?

[skeptic_]

Yes i wanted to purchase Skunk2 Pro's Intake manifold's from the US which is for the b18c1 wondering if that will fit, aswell as the headers such as them 4-2-1.
Will it fit ?

[EKVTIR-T]

Yes and yes

[Super-DA9]

yep all good man, parts from the gsr will bolt up fine as long as they arent affected by the LHD/RHD difference :)

[skeptic_]

sorry to bring up an old thread,
So GSR(USDM) headers, Intake and Exhaust will fit a VTI-R(AU) integra. Same year model irrespectively.

[dougie_504]

Was that a question?

Headers will fit between all B series (at the ports, sump clearance another issue depending on block).

Intakes are interchangeable.

Exhaust will be fine.