60 degree fan switch

[jetdc2R]

hey guys

im after a fan switch that turns on at 60 degrees ? ive looked at all brands but cant seem to found anything ..

i have a hondata can i program that to work with the fan ?

thanks

[stndrd]

DRIFT make an electronic fan controller that you can pre set

http://www.shopdrift.com/Products/Electronics/RadiatorFanController.aspx

[IV73CI]

Apart from DRIFT products,

there are others like Js-Racing, Mugen, Spoon, Mishimoto, etc etc that makes low temp fan switches.

If you dont want to spend $70+ on the fan switches,

just adjust it via the hondata...

[TODA AU]

hey guys

im after a fan switch that turns on at 60 degrees ? ive looked at all brands but cant seem to found anything ..

i have a hondata can i program that to work with the fan ?

thanks

Further to the Drift product there's also the Billion VFC's (& don't have an S300)
http://www.nengun.com/billion/vfc-max
http://www.nengun.com/billion/vfc-elm

Re using the Hondata
If you have a Hondata S100 or S200 you can't actually control the fan through this,
The S300 can though...
Parameters - Protection - Radiator Fan - Override radiator fan control.
But you need to have FANC (A12) connected

Hope that helps

[jetdc2R]

I have mugen thermostat and switch but I want lower than 80 degrees

My s300 isn't connected and I can't find my engine original loom cable so I can tap into from my conversion harness .. I've been searching everywhere but my dc2r loom isn't displayed anywhere it's weird

[IV73CI]

I have mugen thermostat and switch but I want lower than 80 degrees

My s300 isn't connected and I can't find my engine original loom cable so I can tap into from my conversion harness .. I've been searching everywhere but my dc2r loom isn't displayed anywhere it's weird

Dude,

Just look around your computer cables etc. im sure you will have a cable that would suit.

Check out those 3.5in portable HDD some of them are the same cable ends...

[jetdc2R]

I've looked but the only way for me to test is to 12v to the cables and see which one clicks the fan on
Cause I can't find a diagram that looks my loom & I don't think it's safe to just start putting 12v to random cables

[jetdc2R]

all good guys ran a wire from the s300 conversion harness (A12) straight to fan switch and i currently have the original fan switch unplugged, works perfect

thanks

[TODA AU]

No problem

[Sexc86]

adrian, when changing you fan temp via s300, do you need a relay if you are cutting that circuit into a different ecu output?

[TODA AU]

I would, as the ECU is a switching earth.
But you could cheat & run a wire from the fan switch - positive side to A12
Then the factory relay would be operational.
& if you spliced it, the fan switch would act as a fail safe.