90civicGL
13-04-2012, 03:23 PM
My service manual doesn't include it for some odd reason, well its not under front suspension torque specifications or listed in the sway bar removal section.
The 84-87 model they put 16ft lb for both endlinks and bushing holder bolts.
But after googling I found on corvette forums they said 49-70 ft lb (for corvette sway bars) Different car I know, but figures are so different.
So I was wonder If anyone knew the correct figures as its the last thing to do before wheels go on ground. I tried 16 ft lb and I never actually reached it. The bushings where looking VERY squashed so I stopped, is this normal? Or is it meant to be loosish (without being loose).
Thanks everyone, looking forward to a speedy answer. :)
The 84-87 model they put 16ft lb for both endlinks and bushing holder bolts.
But after googling I found on corvette forums they said 49-70 ft lb (for corvette sway bars) Different car I know, but figures are so different.
So I was wonder If anyone knew the correct figures as its the last thing to do before wheels go on ground. I tried 16 ft lb and I never actually reached it. The bushings where looking VERY squashed so I stopped, is this normal? Or is it meant to be loosish (without being loose).
Thanks everyone, looking forward to a speedy answer. :)