Need help with my Speedo please

[Monetz]

http://www.youtube.com/watch?v=xd9dqqWOVIg&feature=youtu.be

hey guy after i'm install my jdm engine and Ek9 5 Stud into my DC2 and after i turn ignition on and look at my speedo just rev to 60 km and after i start the car up engine light come up to so i just wonder did anyone know what wrong and how to fix it?

[dorikin]

hey guy there are some minor wiring differences between early model DC2 and Type-R's. You will need to re-pin your cluster plugs to suit. This should help http://www.ozhonda.com/forum/showthread.php?103192-DC2R-Cluster-in-a-GSI-or-VTIR&p=2020075&viewfull=1#post2020075

short the 2-pin SCS connector to check your CEL codes http://www.ozhonda.com/forum/showthread.php?67113-DIY-PGMFI-Diagnostics-Codes

[Monetz]

thx man will check it out Thank you alot man

[Monetz]

r u sure is the wire? coz i put my vti-r Cluster back on still do same thing even try P72 ECU still do the same thing!!

[dorikin]

check the VSS

[Monetz]

will check VSS 2moro but thing is my car is a dc2 vti-r 4 Stud but i drop EK9 5 Stud conversion in and i still use vti-r ABS Wheel Speed Sensor would they be a problem?

[ECU-MAN]

no, that will only effect ABS
you have something sending a pulse to the VSS input of the ECU, you will need a scope to check the VSS line

[Monetz]

no, that will only effect ABS
you have something sending a pulse to the VSS input of the ECU, you will need a scope to check the VSS line

even i unplug the VSS line they still do same thing so is should b ecu? or have to rewire Cluster ?

[ECU-MAN]

it could be anything

something is sending a signal on the wire to the ECU for the VSS input

[Monetz]

it could be anything

something is sending a signal on the wire to the ECU for the VSS input

thx for help i'll try to rewire cluster plugs