17x9 +35 with 215/45 tyres all round on S2000 ??

[subie]

Guys,

just wondering how's 17x9 +35 offset with 215/45 tyres all round on S2000 will be ok to run?

from a bit of research, it told me that all guards need rolled, rear bar tap need relocated, about -2 camber at the rear

would it be ok to run 215/45 at the rear? would it be ok to have same size tyre front and rear?

thanks in advance guys

[Areis]

Try using 215/40/17 tyres. Will make fitting a lot easier.

[JN7]

215/45 is fine but it may be a bit too much stretch.
you can easily run 225/40 with -2ish camber with the relocated bumper tab.
all down to what look you're after (stretched or meaty tyres)

try look at www.rimtuck.com and have a look at the set ups that are closest to you.

[barefootbonzai]

NOT POSSIBLE! -> http://www.ozhonda.com/forum/showthread.php?163547-Tire-Stretching-thoughts-and-recomendation...

[JN7]

lmao duy

[VeYzZii]

NOT POSSIBLE! -> http://www.ozhonda.com/forum/showthread.php?163547-Tire-Stretching-thoughts-and-recomendation...

Still a comedian. But yea, subie i would read that thread. Its pretty much the same.

[ALPS]

on 17s i would want meatier. i'd go with JN7s suggestion except 225/45s. also check out www.tyrestretch.com

should have very little stress fitting them on the front, and near none on the rear. and i would try go staggered fitment, rather than same fitment all round.

[le do]

I'm running 17x8 and 17x9 +40, do you think that 235/40 will fit the front. im running -2.0 camber in the front and lowered with about a finger gap between the fender. my fenders are rolled, but they arnt pulled and i dont want to scrub. what do you guys think or should i just go 225/45? only reason is the tyres i want they dont make 225's and only do 235's. thanks in advance