b16 heads

[AllMotorB16a]

hey guys rebuilding my b16 head and i was wondering im taking 0.40'' off the head and wonder how thick of a head gasket i should run? also changing to arp head studs... also wondering what what you guy reccomend like how much off the head and yeah looking for a bit of an compression rise :) thanks

[gen2 CRX]

If your rebuilding your b16a motor just give the head a standard resurface. Use a standard head gasket with civic type r pistons. The CTR pistons will raise your compression from 10:4 to 11:1 compression ratio (same as b18c7) which is good compression for a street motor. If you want a bit more then that you can get a 2 layer headgasket. If your not re building the block and just getting your head serviced use the 2 layer headgasket combined with milling the head. You should ask your machinist for advice on how much to remove. I dont think it will be as effective as the CTR pistons though.

[shepparton]

excuse me, do you have to spam the topics on forum so many times that you are going to rebuild your engine? like anybody care??

[AllMotorB16a]

excuse me, do you have to spam the topics on forum so many times that you are going to rebuild your engine? like anybody care??

got a problem? :D

[shepparton]

i think you the one that having problem, bro

all the topic you posted are for junks, useless material to read and response. Its like talking same sht over and over again