xjm
29-06-2012, 05:54 PM
Hi All,
I had to replace the in-tank fuel pump with another type.
but - connectors werent the same. The old one was a nut and bolt type. The new one used those plastic connectors.
So I intend to solder ends of wiring and crimp.
- BUT, not doing so because it might be incorrect let alone outright dangerous?
- Anything I can do further? What sort of insulation is there thats good to sit with the fuel? or what else do I need to protect?
I had to replace the in-tank fuel pump with another type.
but - connectors werent the same. The old one was a nut and bolt type. The new one used those plastic connectors.
So I intend to solder ends of wiring and crimp.
- BUT, not doing so because it might be incorrect let alone outright dangerous?
- Anything I can do further? What sort of insulation is there thats good to sit with the fuel? or what else do I need to protect?