View Full Version : How do I mount number plate on CRX SiR?
trancier
10-03-2005, 12:44 PM
Just picked up my 89 CRX SiR from VicRoads but the VIC number plate is ~1-2cm too wide for it to fit in the rear bumper recessed mounting hole. Before I go trimming it or calling Vicroads, just wondering if anyone had any suggestions?
SINISTR
10-03-2005, 01:35 PM
hey mate,
you will find that problem on a fair few JDM cars.
the easiest way is to slightly bend the corners out. Usually creasing just around the lines is substantial enough - make sure you support the plate on a brick or wooden block - even a benchtop - put something soft and hit it with a rubber hammer.
trancier
10-03-2005, 01:50 PM
thanks for the reply
you were right - I ended up bending the corners using pliers. Fits perfect now :)
Setanta
10-03-2005, 06:09 PM
I just cut about 2mm off each end of mine, added some rubber to the rough edges and bolted it on =)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.