Auto Problems HELP HELP HELP

[Auzziebiker]

The Car A 1990 3 door Honda Civic Automatic D15B4 Motor Not Sure what model the gear box is bit is the original One

Problem had a damaged main drive shaft oil seal I replaced that and added the right amount and type of Oil and it wont change gears. I can select 2nd manually but it wont auto select it just stays in 1st gear I checked the kick down cable and it is as it should be.

Please HELP HELP HELP


Update The Oil Is The One Recommended by 3 different company's
Castrol TQD III


Latest Update
I have tried cycling through the gears like is says in the manual still no change
the gearbox is a L4 Automatic if anyone has one that works that you want to sell me let me know (Must be in good order and remember I am in Queensland (I will Pay For Shipping))

[ECU-MAN]

what type of Fluid did you put back in

did you check the fluid level while the trans was hot and within 10 seconds of turning off the engine ? if so where on the dipstick is the oil level

did you have any slipping or gearchange issues befire replacing the seal ?

[EKVTIR-T]

Yeah needs to warm up and circulate through the transmission.

Start it and hold the brake,then select through each gear and leave it in each for a while like P N R D D2 etc.

Then back into D and let out the brake a little and see if it pushs once circulated

[Auzziebiker]

New gearbox arrived at 8:30am today I will be fitting it next week and then I will be mobile Finnaly