k20 manifolds??

[Beechy]

just wanted to know what the diffrence in the rbc and skunk2 manifolds are like power gains which is better? or should i just port out the oem k20a one?

[infurNOS]

RBC intake manifold vs Skunk2 Manifold:


http://honda-tech.com/showthread.php?t=2730401
http://www.8thcivic.com/forums/intake-spacer-discussion/173289-rbc-vs-rrc-vs-skunk2.html

Prob be good to post this in the technical section.

[Snoop_gee]

http://image.superstreetonline.com/f/techarticles/sstp_1002_k_series_intake_manifold_shootout/27556414+w640/sstp_1002_01_o+k_series_intake+manifolds.jpg
the best article i have found in comparing differences in K-Series manifold is this (http://www.superstreetonline.com/techarticles/sstp_1002_k_series_intake_manifold_shootout/viewall.html)

IMO for the money you spend choosing/buying the skunk2 intake manifold i would purchase the RRC.

[stndrd]

I would purchase the All In Fabrication intake manifold. Good gains have been seen on n/a motors but massive gains have been seen for f/i setups

[Benson]

What motor ? If its OEM k20a motor, just leave the OEM manifold.

Skunk2 and All in one wont see much gain on a OEM k20a motor.

[euRo_noob]

What motor ? If its OEM k20a motor, just leave the OEM manifold.

Skunk2 and All in one wont see much gain on a OEM k20a motor.

What about a K24Z3?