DC2 VTi-R conversion to TypeR EXTERIOR

[3KNST9]

hey there guys im looking for some help or some form of direction to how i would go about patching up the holes left by removing the exterior side door moulds and making the body more clean. ive seen it done to a few DC2 VTi-R so i know its been done before.

would be heaps convenient if someone could point me to a bodyshop/smashrepairer/etc who can assist me with this as well.

cheers!

[void-]

tbh any bodyshop can do it... they will either bog it then sand it down then respray.. or weld it then sand it down again then respray.. its what you want

[eLtrix]

^ Just take it to any local body shop/ panel beaters. They will probably be able to do it, should call around or look around before you go with it to get the best price

[CivicEGSI]

paint duct tape the same colour as your car, stick it over the holes, done.