PDA

View Full Version : 5 stuf conversion cxi


Hellomotog
02-09-2012, 07:15 PM
Hey guys. anyone know what parts i should be looking for when i buy a 5 stud conversion.

i have a cxi so my rear brakes are drum.. :(

some people say i need a brake booster and others say dont worry....

so ye just a list would be cool. thanks heaps in advance
brandonek1
02-09-2012, 08:59 PM
Front hubs, knuckles, rotors, calipers
Rear trailing arms, Handbrake cables, hubs, rotors, calipers
Brake Booster, Master cylinder, Prop valve

From what i've read - you don't need to upgrade the brake booster, master cylinder and prop valve but the setup won't be as effective if you don't
Hellomotog
02-09-2012, 09:07 PM
Legend!
ichi-go
02-09-2012, 10:11 PM
Does the cxi driveshaft fit the 5stud hub?
brandonek1
03-09-2012, 07:24 AM
Depends what car you get the conversion from. Example. EK1 has 32mm hubs, JDM ITR has 36mm hubs - need drive shafts too
Hellomotog
03-09-2012, 04:10 PM
I'm running a b18c7 would I have the right driveshafts already
brandonek1
03-09-2012, 04:45 PM
Should be fine!

UKDM/EDM/CDM/AUDM ITRs are all 5x114.3 and use the 32mm spline. What year Civic are you putting it on?

Take the knuckle and trailing arm assemblies, brake lines, and ebrake cables. If you have an EK, I would take the master cylinder. If you have an EK hatch, most likely you won't need to change the prop valve, but in any case I would get it from an EK4 or EM1.


http://honda-tech.com/showthread.php?t=2260265
Hellomotog
05-09-2012, 10:00 AM
What about brake lines. My civic has 10mm fittings because no abs. Apparently the dc2r one has 12mm

Also I have a master cylinder and brake booster off an integra vtir. Will that work better than my existing one?

Can anyone post a photo of the proportional valve
ECU-MAN
05-09-2012, 01:18 PM
you do not need to change the rear trailing arms. You can remove the rear drum hub from the arm and fit the disk hub and bolt the rest on.
Hellomotog
05-09-2012, 02:51 PM
what then happens with the handbrake?
ECU-MAN
05-09-2012, 06:04 PM
replace the cables with the disk brake cables from an integra DC2 or EK with rear disk
cbauto
05-09-2012, 06:39 PM
I'm looking for parts to do a 5 stun conversion too.
ECU-MAN
06-09-2012, 11:25 AM
I'm looking for parts to do a 5 stun conversion too.

then create a thread in the Wanted To Buy Section
mocchi
06-09-2012, 11:32 AM
also need to replace rear brake lines.
cant use drum on disc line on your 5 stuf

you need torx screw to remove the rear hub assembly if you dont wanna drop trailing arm
cant remember what size though
cbauto
15-10-2012, 11:33 PM
thanks for info