View Full Version : Replace driveshaft for EG civic with DC2R conversion
JanetJacobs
06-09-2012, 11:52 AM
Hi,
Am hoping someone can answer this for me, a mate is needing to order replacement drive shafts for his EG civic with DC2R conversion, should he get eg driveshafts or teg ones?
I'm not so good with conversion details, tried reading through a few posts but couldn't find an explicit answer.
Cheers all.
mocchi
06-09-2012, 12:01 PM
depends on what dc2r he went with
jdm (36mm hub nut) or audm (32mm hub nut)
dorikin
06-09-2012, 12:11 PM
And what engine/ gearbox
JanetJacobs
06-09-2012, 12:40 PM
Hi,
It's an aud b18c7 conversion.
Benson
06-09-2012, 01:04 PM
We got the right shafts in stock
Shoot me a PM to order
dorikin
06-09-2012, 01:37 PM
Measure the CV nut, if it's 32mm get DC2R driveshafts (AUDM)
JanetJacobs
06-09-2012, 02:01 PM
Thanks,
So I've told him to order 32mm dc2r (au) drive shafts....correct?
EK1.6LCIV
06-09-2012, 03:42 PM
remove shafts, rebuild with new parts, a lot easier than stuffing around
prob set you back 300 at the very most
dorikin
06-09-2012, 04:30 PM
Correctomundo
mocchi
06-09-2012, 04:33 PM
Correctomundo
http://animebuddy.net/file/pic/photo/b239ffba1396fcb7c5a8a144b6116a68_500.jpg
kcokla
09-09-2012, 11:23 AM
bump for this -
would a differnt brake setup make a difference?
or all jdm b18c would be 36mm hubnut?
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.