Replace driveshaft for EG civic with DC2R conversion

[JanetJacobs]

Hi,
Am hoping someone can answer this for me, a mate is needing to order replacement drive shafts for his EG civic with DC2R conversion, should he get eg driveshafts or teg ones?
I'm not so good with conversion details, tried reading through a few posts but couldn't find an explicit answer.

Cheers all.

[mocchi]

depends on what dc2r he went with
jdm (36mm hub nut) or audm (32mm hub nut)

[dorikin]

And what engine/ gearbox

[JanetJacobs]

Hi,
It's an aud b18c7 conversion.

[Benson]

We got the right shafts in stock

Shoot me a PM to order

[dorikin]

Measure the CV nut, if it's 32mm get DC2R driveshafts (AUDM)

[JanetJacobs]

Thanks,
So I've told him to order 32mm dc2r (au) drive shafts....correct?

[EK1.6LCIV]

remove shafts, rebuild with new parts, a lot easier than stuffing around
prob set you back 300 at the very most

[dorikin]

Correctomundo

[mocchi]

Correctomundo

http://animebuddy.net/file/pic/photo/b239ffba1396fcb7c5a8a144b6116a68_500.jpg

[kcokla]

bump for this -

would a differnt brake setup make a difference?

or all jdm b18c would be 36mm hubnut?