Removing Honda Symbol off Jazz

[onetwothree]

Is the rear Honda badge stick on or pinned on?

[curtis265]

pinned

[onetwothree]

pinned

How do i remove it then? i want to replace it with the Red Honda Badge cause i currently have the oem chrome badge

[Renaissance_x]

Probably have to take an interior panel off to get to it from the other side.

[curtis265]

How do i remove it then? i want to replace it with the Red Honda Badge cause i currently have the oem chrome badge

i can literally be pulled off. the civic FD one came off easily

[onetwothree]

i can literally be pulled off. the civic FD one came off easily

If it turns our to be a total disaster it'll be your fault lmfao.

[sensei_]

abit far from brisbane > 835 beaufort st no? :p

[curtis265]

If it turns our to be a total disaster it'll be your fault lmfao.

I'm not kidding, the glue was half melted so i just pulled it, watched it stretch slowly and it came off


Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!


abit far from brisbane > 835 beaufort st no? :p

haha dat local knowledge

[GU357]

yeh bro pull it off, heat it up pry a bit with something that wont scratch

[rossirider]

Dont pry it with anything, Heat it up a little with a hair dryer and use some dental floss between the badge and panel and run it back and forth

[GU357]

^ thats a good idea, i pryed mine with a small plastic scraper.more to wedge it out.

[onetwothree]

alright, cheers for the answers. i thought it was glued on but if its pinned i shall try what you guys suggested ;D

[GU357]

i can literally be pulled off. the civic FD one came off easily

BAHAHAHA. ahhhh.

now i remember it having a speednut kind of thing, so after its pulled off u cant put it back in.

[curtis265]

lol really? shit.

the fd one came off with no effort

dead serious

[GU357]

i think the jazz has a speednut/washer thingy on it, like the pins go into the car and then on the otherside they pop a then washer over the pin and that holds it onto the car nice and tight.
if u go to pull it of, the pins snap or the washers do.

but u can still use silicone to hold it in after. i took mine off used a cheap red one (which faded yellow and the red melted and sank to the bottom of the badge), so i grabbed some CF wrap and cut it to shape put the holes in it and made a BOSS cf background badge

[onetwothree]

I'm not kidding, the glue was half melted so i just pulled it, watched it stretch slowly and it came off


Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!



haha dat local knowledge

how did you put the Honda Badge on then? stick the pins in the hole and glued it on?

[curtis265]

the glue was all over the back of the badge so i just pushed it down and warmed it up with a hairdryer. Hasn't come off since

[onetwothree]

the glue was all over the back of the badge so i just pushed it down and warmed it up with a hairdryer. Hasn't come off since

cheers for the answers guys!!

[Vvvtec]

close thread

[RenzokukenJ]

When no one is around you