eg b18 swap vtec wiring

[kcokla]

Can anyone tell me where I need to put the 4 wires hook up to on the obd2a ecu?

I know i need to splice into something or plug into the ecu - but which ones

any help will be appreciated!

diagrams would be even better!

:)

thanks.
:thumbsup:

[stndrd]

In regards to what? Are you doing a b swap on your eg and need wiring diagram or have you chopped your engine loom to pieces and need to re-wire?

More indepth info will get you your answer

[kcokla]

see first post

[stndrd]

Is your DC2R ECU OBDI or OBDII? Is the Rywire harness a mil-spec harness or just a replacement OBDI or OBDII OEM harness?

[bennjamin]

check the MIL codes and tell us what comes up

Click here for a ECU test/check (http://www.ozhonda.com/forum/showthread.php?8218-DIY-CHECK-ECU-for-j00-!)

[kcokla]

Is your DC2R ECU OBDI or OBDII? Is the Rywire harness a mil-spec harness or just a replacement OBDI or OBDII OEM harness?

it is OBD II

i dont know how to answer that, but it allows the OBD2 ecu be plugged into the OBD 1 loom


check the MIL codes and tell us what comes up

Click here for a ECU test/check (http://www.ozhonda.com/forum/showthread.php?8218-DIY-CHECK-ECU-for-j00-!)

Just tried this,
got some codes but when i cross checked it some of the codes didnt exist so clearly i had read it wrong ( tried like 5 times)

consistant one i got was 6, and 21

[stndrd]

You got the rywire OBDI --> OBDII conversion harness. This may sound silly but is the engine loom you are using OBDI or OBDII?

Code 6 is water temp sensor
Code 21 is VTEC spool solenoid valve

For a complete list of DTC check http://www.civic-eg.com/viewtopic.php?t=1558