PDA

View Full Version : DC2 armrest in Civic EG?


pheestyle
17-10-2012, 05:05 PM
hey guys,

i read somewhere that a dc2 armrest can be fitted into an EG
is this true or do you need to modify it?

cheers
kcokla
17-10-2012, 05:45 PM
connection part needs to be modified as the 'teeth' do not line up

you can just get an eg arm rest

there are two types, a long and a short type.

Honda eg sedans - vti's had the short type

and the eg6 had the long arm rest
pheestyle
18-10-2012, 08:10 PM
cheers mate. went to the wreckers today. found a short one in an SI though for 16 bux :D
kcokla
18-10-2012, 08:34 PM
cheap!
Egxris
19-10-2012, 09:55 AM
paid $80~ delivered from overseas lol $16 is crazy cheap.
pheestyle
21-10-2012, 06:56 PM
^ that sucks man. i would never pay that much.

i just did the ek center console conversion. i went to the honda wreckers and they wanted 80 bux for the center console. i told them to get stuff so i went for a 30 min drive to a self serve wreckers and picked it up for 27.

best thing done to my civic so far!
hayashi_1986
29-10-2012, 01:53 PM
^ that sucks man. i would never pay that much.

i just did the ek center console conversion. i went to the honda wreckers and they wanted 80 bux for the center console. i told them to get stuff so i went for a 30 min drive to a self serve wreckers and picked it up for 27.

best thing done to my civic so far!

I never buy off the shelf items from pre pull wreckers. They shaft you any way they can.

Now I pull literally EVERYTHING lol
zhong
29-10-2012, 02:17 PM
^ that sucks man. i would never pay that much.

i just did the ek center console conversion. i went to the honda wreckers and they wanted 80 bux for the center console. i told them to get stuff so i went for a 30 min drive to a self serve wreckers and picked it up for 27.

best thing done to my civic so far!


Pics!
pheestyle
29-10-2012, 08:19 PM
il do it when i have some timee. its not properly snugged up but im quite happy with my efforts. got a couple of more mods until my civic is complete in exterior
pheestyle
05-11-2012, 01:07 PM
Just completed by ek centre console conversion. The trick is to find a shorter din slot compartment and cut the slot in the back panel a little bit smaller than the din slot compartment. It's absolutely solid as a Rock. Only thing down side is that there is a 2cm gap on each side. I'm Trying to figure out what to do next