Best cat 4 dc2r

[etcha]

looking to buy a hi flow cat for my dc2r.
just wana wat type (brand) and cost and where to go in syd

[fly_vti]

:D man, me personally i dont like spoon or mugen cat backs, to 'legal' for me kikiki. for for a apexi at 2" or 2"1/2 max. u can get it done at liverpool exhaust at liverpool. last time i checked u get a nice vtecy sound out of them. with good flow properties for peformance.

[faijai]

:D man, me personally i dont like spoon or mugen cat backs, to 'legal' for me kikiki.

what do u mean?

also i think hes asking for a cat..not catback?
but yeh, most places which fit exhaust will have cats, catco is a familiar brand. take it to exhaust palces like livo exhauts, performance exhautsm hi tech so on. oem jdm cats are also good.

[etcha]

ok kool

[type one]

also depending on whether you are going to get a Japanese "after market" cat back system later on, consider that you will not be able to bolt this straight up to your 2.5" hi flow Cat.

for example a spoon b pipe is about 2-3 inches longer and runs different flange set up to Aus ITR.

[tanghy]

best is if u buy jdm header with 2.5" flange
+ jdm cat
+ jdm catback
all at one shot
then it's hassle free
otherwise here weld there weld

[HyperZ]

best is if u buy jdm header with 2.5" flange
+ jdm cat
+ jdm catback
all at one shot
then it's hassle free
otherwise here weld there weld

Thats right, i got a high flow magnaflow few days ago, weld here weld there (on the CAT of course), and now my exhaust pipe is rattling against my rear lip because the measurements when they modified the cat wasnt exact!! ARGH!!

On a side note, does anyone know whether high flow cats make a hissing noise??

[tanghy]

sounds like a leak

[Boost]

poor welds...

[LAGOOT]

i got 2.5" catco cat from fussy's when i got my exhaust installed
no problems :thumbsup:

[etcha]

well iv alread got a cat back exhaust(mugen 2.25in),came with the car when i got it