brake issue

[aznstyler]

hey guys, just did a conversion in my eg. and now 90% of the time the brakes will work, and after awhile the pedal will just go staight to the floor but still have a tiny bit of brake left, and then if i start pumping it will go back to normal. what could be the cause of this?

[bennjamin]

what conversion ? Brake conversion ? Did you replace the master cylinder/brake booster from the upgraded brakes , as well as the prop valve ?
Did your eg have 4 wheel discs before ?
Did you bleed your fluid properly ?

[aznstyler]

sorry engine conversion *

[aznstyler]

Bumpp

[infurNOS]

Answer bennjamin other questions first instead of bumping, so we can help you better.

[aznstyler]

i already answered the question

[infurNOS]

i already answered the question

Are you sure ?


what conversion ? Brake conversion ? Did you replace the master cylinder/brake booster from the upgraded brakes , as well as the prop valve ?
Did your eg have 4 wheel discs before ?
Did you bleed your fluid properly ?

5 questions asked above


sorry engine conversion *

You answered 1

[bennjamin]

i already answered the question

If the pedal sinks at all , it's either air in the brake fluid circuit or leak at some point. Either loose nipple , bent or scarred line or bad master cylinder.

Did you touch the brakes at all - service them , change them in any way ?
Since the brakes must be pulled away or even remove when the conversion is done , I would suspect they require to be bled again properly and thoroughly.