PDA

View Full Version : Headunit turns off when Vtec engages



TOm.C
23-11-2012, 12:57 PM
when i hit vtec my headunit will turn off
then back on after 5-7 seconds when out of vtec
what could be causing this?
this is in a em1 wtih b16a
only mods to car are Pod filter and lowered.

Indie
23-11-2012, 01:57 PM
Perfect! Lets you hear the VTEC, yo.

connorling
23-11-2012, 02:03 PM
could be a loose power wires and when u vtak, it pushes the head unit back and loose the connextion. since it turns off, i think you should check the power wire coming out from your head unit to the power source and see if there is any damaged.


when i hit vtec my headunit will turn off
then back on after 5-7 seconds when out of vtec
what could be causing this?
this is in a em1 wtih b16a
only mods to car are Pod filter and lowered.

lolmclol
23-11-2012, 02:26 PM
Perfect! Lets you hear the VTEC, yo.

DAT CONSIDERATE ENGINE, YO!

lel

butterfingers
23-11-2012, 02:35 PM
lmfaO

void-
23-11-2012, 02:39 PM
get your earth grounding line is loose and gets more loose when you engage vtec... i would suggest to pull the deck out and checks the wires...

TOm.C
23-11-2012, 03:36 PM
could be a loose power wires and when u vtak, it pushes the head unit back and loose the connextion. since it turns off, i think you should check the power wire coming out from your head unit to the power source and see if there is any damaged.
I've checked all power/ground wires, nothing is loose or damaged.

JDM DC2R
23-11-2012, 04:04 PM
The Engine is drawing so much power in vtec. That it sucks all the voltage from the battery. I think u better down grade your motor. Or at least look at a bigger alternator and battery to handle all that power and current drawn during vtec!


Other than the reason above. I doubt it be a ground from the motor to the chassis. As the inner car circuits have a separate ground! Pull your deck out and check the wiring. Also check the fuse box to see that the fuse in in correctly. not half hanging out!.

curtis265
23-11-2012, 04:20 PM
Check your vtec fluid

curtis265
23-11-2012, 04:21 PM
on a more seirous note, is your alternator keeping up? Does anything else die?

DBSTF
23-11-2012, 08:05 PM
take your head unit out and check if the plugs and wires are loose !

johnsta
23-11-2012, 08:06 PM
suck shit mate

viinnh
23-11-2012, 08:08 PM
suck shit mate

whatta dick

u mad?
23-11-2012, 08:40 PM
suck shit mate
Lmaoo

jase_scott
23-11-2012, 09:56 PM
My money is on a pretty little vafc or similar sitting on the dash once upon a time...
Check for any evidence of anything being spliced into the head unit wiring.

JDM DC2R
23-11-2012, 10:28 PM
My money is on a pretty little vafc or similar sitting on the dash once upon a time...
Check for any evidence of anything being spliced into the head unit wiring.

Who would wirer it up like that. Every cable you need is at the ECU but the dimmer light when u put the dash lights on!!!!!!!!!!!!!

mocchi
23-11-2012, 10:34 PM
Perfect! Lets you hear the VTEC, yo.

lmao it noes

hahahahah awesome thread m8 ay it can w8

jase_scott
23-11-2012, 10:41 PM
I'm just a noob dude, cut me some slack huh?

Where's the ecu wiring?
Where's the headunit wiring?
Where do you think the average vafc(or similar) buyer gets the the new toy home, pulls out the diagram and starts cutting wiring in without knowing much about what he's doing?
Probably doesn't even know what an ecu looks like.
Get my drift?
I've seen it all before mate...

mocchi
23-11-2012, 10:46 PM
I'm just a noob dude, cut me some slack huh?

Where's the ecu wiring?
Where's the headunit wiring?
Where do you think the average vafc(or similar) buyer gets the the new toy home, pulls out the diagram and starts cutting wiring in without knowing much about what he's doing?
Probably doesn't even know what an ecu looks like.
Get my drift?
I've seen it all before mate...

yea man, some ppl try to diy and fcuk it up thats possible

jase_scott
23-11-2012, 11:07 PM
What's even worse mocchi is you get fkups from people simply trying to remove said devices from the vehicle, that may have even been wired correctly to begin with.

jase_scott
23-11-2012, 11:10 PM
Btw I wasnt addressing you in the first instance mocchi, you snuck in there while I wasnt looking.

JDM DC2R
23-11-2012, 11:36 PM
I'm just a noob dude, cut me some slack huh?

Where's the ecu wiring? Left of passenger feet
Where's the headunit wiring? Behind the deck
Where do you think the average vafc(or similar) buyer gets the the new toy home, pulls out the diagram and starts cutting wiring in without knowing much about what he's doing? Took me 2 minutes to cross reference the honda diagram and the apexi one
Probably doesn't even know what an ecu looks like. a box with cables going into it
Get my drift? FF's dont drift, we power slide ;)
I've seen it all before mate... Install should take 5 minutes. It was like 7 connections

eLtrix
23-11-2012, 11:39 PM
This is how it should be, trust me! Gotta hear all that v-tac YO!

jase_scott
23-11-2012, 11:42 PM
Cool, my little rex did 13.8@100 too.

Like I said, you're the expert, I'm just trying to learn here...

Edit: Snaked again...

mocchi
23-11-2012, 11:43 PM
Install should take 5 minutes. It was like 7 connections

http://1.bp.blogspot.com/-ynjIljofe3A/T76LgLAjGrI/AAAAAAAAC5A/9Zq8IzWW598/s400/watch-out-we-got-a-badass-over-here-meme.png

JDM DC2R
23-11-2012, 11:48 PM
Cool, my little rex did 13.8@100 too.

Like I said, you're the expert, I'm just trying to learn here...

Edit: Snaked again...

Id say im ok with cars no expert. But im a industrial electrician. Hence i no my wirring. Every one learns.

Also i love the old scool rex's

jase_scott
24-11-2012, 12:15 AM
Wow, this is getting spooky,
I luv jap dc2rs.
Ever been past that Westons fully automated flour mill on the Hume at strathfield there?
I spent 4years there, doing a whole heap of shit, from pulling and fitting off 3phase and neutral xlpe 500's,right up to fitting out and commissioning the mcc's.
Threading your elbows between live 2kA buses with the nearest fuse all the way back at the substation, steel conduit, having to call the supply authority to get permission to startup a single motor, ahhhh.... Used to luv all that stuff....

lolmclol
24-11-2012, 12:37 AM
I'm just a noob dude, cut me some slack huh?

Where's the ecu wiring?
Where's the headunit wiring?
Where do you think the average vafc(or similar) buyer gets the the new toy home, pulls out the diagram and starts cutting wiring in without knowing much about what he's doing?
Probably doesn't even know what an ecu looks like.
Get my drift?
I've seen it all before mate...

asking a forum instead of consulting a professional ... then getting angry for sarcastic responses

*slow clap*

jase_scott
24-11-2012, 12:51 AM
Who's angry?
Think you're spending too much time reading between the lines, that's what females do.
Try reading on the line instead.

dougie_504
24-11-2012, 08:32 PM
Stay on topic OzHomos!


Check the wiring around your VTEC solenoid and just make sure it's all tight/intact. Also clean the grounds in your engine bay (wires bolted to the chassis, just take them off, sand the grounding points, and re-attach).

Just hoping but probably not the issue..

GU357
26-11-2012, 04:39 AM
is battery condition ok?
are you dead sure its once vtec kicks in?

or maybe since the stereo is off it sounds louder?

who knows.

maybe the other guy wired it up for spirited driving and cruising modes.

aaronng
26-11-2012, 07:13 AM
Your VTEC solenoid might be somehow grounded to your headlights? Is the ground wiring original or has someone put together an aftermarket ground/capacitator kit?

JDM DC2R
26-11-2012, 12:06 PM
When in doubt install a flux capacitor!

TOm.C
26-11-2012, 09:13 PM
dont know what i did, but it doesn't happen anymore.
thanks everyone who tried to help out

JDM DC2R
26-11-2012, 09:25 PM
dont know what i did, but it doesn't happen anymore.
thanks everyone who tried to help out

Flux capacitor fixed it for sure!

GU357
27-11-2012, 01:47 AM
check your oil maybe you ran out of vtec fluid?

JDM-derek
13-04-2013, 06:03 PM
Vtec yo