PDA

View Full Version : Synchro Ring Change


SHRUKA
11-02-2013, 12:31 PM
Hey guys,
I drive an EP3R and sometimes when i shift from 1st gear to 2nd gear, it sometimes crunches or gets stuck in between. Could be the synchro ring is worned out or something?
It makes my daily driving sometimes a pain in the ass.
hoaanguyen
11-02-2013, 12:50 PM
change the transmission fluid, might be low.
curtis265
11-02-2013, 12:51 PM
change the transmission fluid, might be low.

+1 to this suggestion. What fluid is in there at the moment?
fillit
11-02-2013, 12:51 PM
try redline MT90 or lucas oil before you start any expensive rebuild.

I've had a similar issue with my old car, I changed it to royal purple and it was a lot smoother, then it turned out the throw out bearing was playing up, changed the clutch, put in MT90 and it never crunched again.
SHRUKA
11-02-2013, 12:59 PM
I was thinking the same, will get it checked out and refresh with new transmission fluid.
SHRUKA
11-02-2013, 01:00 PM
+1 to this suggestion. What fluid is in there at the moment?
Im not sure what fluid is in there at the moment but I will most likely empty it all out and refresh it with some new fluids.
SHRUKA
11-02-2013, 01:02 PM
try redline MT90 or lucas oil before you start any expensive rebuild.

I've had a similar issue with my old car, I changed it to royal purple and it was a lot smoother, then it turned out the throw out bearing was playing up, changed the clutch, put in MT90 and it never crunched again.
I've recently put in a brand new clutch and flywheels but I will check out those oils. Thanks!
fillit
11-02-2013, 01:16 PM
I've recently put in a brand new clutch and flywheels but I will check out those oils. Thanks!

Just a tip when you do, open the filler bolt before you take out the drain bolt.

If you take out the drain bolt and the filler bolt is seized, you will be in big trouble.

However if you've changed your clutch recently, that shouldn't be an issue (still a good habit to get into)
dougie_504
11-02-2013, 03:40 PM
Pushing the clutch pedal nice and hard?

And yeah try the clutch fluid.
SHRUKA
12-02-2013, 12:16 AM
Pushing the clutch pedal nice and hard?

And yeah try the clutch fluid.

Always pushing the clutch in before i switch gears!
dougie_504
12-02-2013, 12:39 AM
Yeah of course, just saying make sure you push it hard and all the way down. A quick hard push to the floor. If it's a little bit off the floor then it won't engage as well as it could and this will cause crunching/sh!t shifting.
integraR
18-02-2013, 07:30 PM
use honda's mtf (manual transmission fluid)
stndrd
18-02-2013, 07:58 PM
Penrite TransGear 75W80 or ProGear 75W85