Andy
07-03-2013, 08:00 PM
Just want to ask a few questions regarding my issue to see if anyone else has come across it and can shed some light:
*The colour of my CAN connector is blue and the one on the Hondata instructions says its meant to be green, does it matter? (99.9% sure its the CAN connector, according to http://hondata.com/downloads/04-06_flas ... nstall.pdf)
*Also are the Red and White wires meant to go into the same pins on the CAN connector, as the instructions are for the USDM TSX not the AUDM Accord Euro?
*Last question; When I put the Red and White wire through DLC(OBD2) connector they only go through about half way(on the terminal side) and wont go budge any further.. a bit paranoid that when I take it to Honda to get my immobilizer reprogrammed the pins on their OBD2 tool wont be long enough. Was this the same case for you guys?
I have provided pics, sorry about the quality but its enough to get the general idea
,Any help would be great :D
DLC(OBD2) connector pics
24255
24256
*The colour of my CAN connector is blue and the one on the Hondata instructions says its meant to be green, does it matter? (99.9% sure its the CAN connector, according to http://hondata.com/downloads/04-06_flas ... nstall.pdf)
*Also are the Red and White wires meant to go into the same pins on the CAN connector, as the instructions are for the USDM TSX not the AUDM Accord Euro?
*Last question; When I put the Red and White wire through DLC(OBD2) connector they only go through about half way(on the terminal side) and wont go budge any further.. a bit paranoid that when I take it to Honda to get my immobilizer reprogrammed the pins on their OBD2 tool wont be long enough. Was this the same case for you guys?
I have provided pics, sorry about the quality but its enough to get the general idea
,Any help would be great :D
DLC(OBD2) connector pics
24255
24256