View Full Version : Engine mount doesn't line up.
indo_Mi
13-03-2013, 05:04 PM
Hi all,
I was helping a mate change his engine mounts on his EK that he bought with a B18 conversion.
indo_Mi
13-03-2013, 05:11 PM
....any how, all the mounts were fine and line up...except the passenger lower torque mount (as can be seen in the pic).
The body& chassis is and looks very straight, and does the placement of the motor. Is it possible the previous owner used the wrong mount bracket? Or can I get a bracket that will line it up?
Any help would be great.
24318
As u can see its off Center by at least 1-2cm!
dorikin
13-03-2013, 05:14 PM
what bracket is that
indo_Mi
13-03-2013, 06:06 PM
Its the lower passenger side engine mount, also known as a torque bracket.
bennjamin
15-03-2013, 07:22 AM
Hi all,
I was helping a mate change his engine mounts on his EK that he bought with a B18 conversion.
does the Drivers side line up the same degree ? It's not too far off , but should be rectified if you are to run front torque mounts.
Can I suggest to run stiff engine mounts like innovative or has port- which removed the need for the front torque mounts.
Just remove them ! Saves a chunk of weight and looks cleaner.
SU-WOOP
21-03-2013, 02:58 AM
they have probably used an eg/dc t bracket for the rear if that torque mount doest line up theres no way that either of the side mounts do either
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.