DC2R 5 stud suit EK1 D16Y?

[justin333]

Hi guys,

i have searched the forum but confusing abt the answer, just wonder:

Can DC2R 5stud conversion fit on my civic EK1 with D16Y1 SOHC engine?

Somebody said direct bolt on, but somebody also

said the spain of driveshaft for the B-series is different

with the D-series driveshaft so can't putting it on unless u r running on B16 or 18


any ideas guys?
cuz planning to get one set but confusing now so....
Thanks a lot

[carayan]

yeah fits all good, just need all the stuff like knuckles etc etc

[akusuma]

there are 32mm and 36mm driveshafts, need to find AUDM dc2r (32mm) for direct bolt on

[justin333]

there are 32mm and 36mm driveshafts, need to find AUDM dc2r (32mm) for direct bolt on

Aftermarket part will do??

[jajaja]

Did this on my ek d16. Used all the parts from an aus spec dc2r (32mm driveshafts).

[justin333]

Did this on my ek d16. Used all the parts from an aus spec dc2r (32mm driveshafts).

thanks mate will try to look for one then cheers again

[jajaja]

Btw if youre doing it on an ek you will need handbrake lines from an ek with rear discs as dc2r ones will be too short and will not work properly.

[viinnh]

my 5 stud conversion was off a EK9, so thats 32mm drive shaft hub, which would be your d16
if you get a 5 stud conversion make sure its a EK9 one or a AUDM DC2R as the jap spec DC2R is 36mm
and if its DC2R, make sure you have EK hand brake lines as DC2R are longer

[justin333]

my 5 stud conversion was off a EK9, so thats 32mm drive shaft hub, which would be your d16
if you get a 5 stud conversion make sure its a EK9 one or a AUDM DC2R as the jap spec DC2R is 36mm
and if its DC2R, make sure you have EK hand brake lines as DC2R are longer

thanks for the reply mate,
so i need to find EK Rear disc handbrake cable like GLI model?

Cheers

[dorikin]

DC2R/EG handbrake cables are shorter, not longer than EK

EK chassis longer wheelbase