noob question ; 99' CRV 36mm front driveshaft fit jdm DC2R 36mm hubs?

[jdmEG5]

Hi guys,

Noob question..

I was working on a 99' CRV (b20b motor) today and i realised they have 36mm hubs..

Well, I have a DC2 with JDM 5 stud conversion (36mm hubs) but my cv at the moment had been retrofitted with my original ones (I used 36mm outer with my original 32mm shaft) and it sorta have some slight play..

Now I was thinking, instead of me having to retro mine again - if they ever get damaged, am i able to use the CRV driveshafts on mine??

Would i have any issues with the length?



#noobquestiondonth8lol

[cbauto]

bump

anyone?

[carayan]

You can use:
-crv
-prelude (5stud, 32mm inner, 36mm outer)
-accord (5stud, 32mm inner, 36mm outer)
-jdm dc2r (duh)

You can swap outers with:
-Crv
-prelude
-accord
-dc5

[cbauto]

You can use:
-crv
-prelude (5stud, 32mm inner, 36mm outer)
-accord (5stud, 32mm inner, 36mm outer)
-jdm dc2r (duh)

You can swap outers with:
-Crv
-prelude
-accord
-dc5
so.... Say I have 36mm dc2r shafts and I want to rebuild it. I should buy CRV/Praylude/Accord 36mm outers? all should work?

What about the Hub? jdm dc2r hub is same CRV/Praylude/accord?

[carayan]

so.... Say I have 36mm dc2r shafts and I want to rebuild it. I should buy CRV/Praylude/Accord 36mm outers? all should work?

What about the Hub? jdm dc2r hub is same CRV/Praylude/accord?

I'd say get prelude/accord outers, from what i read and what ive seen they are identical to audm 32mm shafts (internal wise) just have 36mm outers

jdm dc2 same as crv, probably easier to source crv, although i think crv width is slightly smaller (width of hub), give you a little less offset (thats compared to audm dc2 tho)