Abs help on 5 stud conversion

[jn093]

Hi guys doing a 5 stud conversion on my ek4 this week end and a few things I need to be cleared up before I go ahead with it.

1. Will the aus spec dc2 abs sensors fit, plug and play ek4 abs?

2. If it does fit will the ecu pick up on it or will it mess me up more?

I had a look around different forums and sites, but most if not all the 5 stud conversions are non abs. Any help would be great. Thanks

[bennjamin]

Pretty sure you can reuse your existing ABS sensors - besides , the sensor runs off the existing driveshaft. The mounting is the same front and rear