sensei_
07-04-2014, 03:51 PM
I have been trying to rebuild an alternator from a CL9 (K24 engine).
So far, I think I'm going to need new brushes. Current brushes sit at 7.5mm, where the minimum limit is 5mm.
However in my infinite wisdom, I decided to "remove" the top plate that consist of the connector and plate that allows the brush to screw onto.
Can anyone tell me if it is possible to buy that particular plate? And the cost if need be.
Or am I better off just buying some aftermarket alternator?
26684
So far, I think I'm going to need new brushes. Current brushes sit at 7.5mm, where the minimum limit is 5mm.
However in my infinite wisdom, I decided to "remove" the top plate that consist of the connector and plate that allows the brush to screw onto.
Can anyone tell me if it is possible to buy that particular plate? And the cost if need be.
Or am I better off just buying some aftermarket alternator?
26684