crx999
20-05-2014, 07:02 PM
Hi guys looking for some info on what is the best way to go about re sleeving the D16a8 block with 78mm sleeves. Not too sure about how to go about it. I read the word Darton a lot ( they must be a good brand ?????? - is this the way to go guys ? ) I have a good machine shop that I use. Just looking for a heads up on what to buy. looking to get some pistons to suit ( will be using a D17 crank ). The motor will be an N/A race motor. Built a D16 stroker race motor ( n/a) for a customer of mine with great success - still going strong. Just kicking around the idea of another project.
Thanks everyone - looking fwd to the replies ( not interested in another vtec build )
Thanks everyone - looking fwd to the replies ( not interested in another vtec build )