mryangtastic
02-10-2014, 08:12 PM
Yeah.
Hi!
Honda newbie here, starting off with a DIY installation for aluminium shifter base bushings.
Few facts before we start:
Factory bushings are rubber
Difference is extremely subtle (almost unnoticeable)
Time taken for me was 3 hours. But I'm not familiar with cars yet. I think I could easily get it done in an hour if I did it again.
There are DIY guides already, but I'd just like to add my experiences, collaborating to the knowledge base on the internet.
Example: http://www.k-series.com/content.php?707-Aluminum-Shifter-Bushings-install-for-EP3-Civic-SI
Found it better to upload my DIY to imgur. Better image quality, easy to add descriptions and looks nicer overall.
Here we go.
http://imgur.com/a/e2FQj
Hi!
Honda newbie here, starting off with a DIY installation for aluminium shifter base bushings.
Few facts before we start:
Factory bushings are rubber
Difference is extremely subtle (almost unnoticeable)
Time taken for me was 3 hours. But I'm not familiar with cars yet. I think I could easily get it done in an hour if I did it again.
There are DIY guides already, but I'd just like to add my experiences, collaborating to the knowledge base on the internet.
Example: http://www.k-series.com/content.php?707-Aluminum-Shifter-Bushings-install-for-EP3-Civic-SI
Found it better to upload my DIY to imgur. Better image quality, easy to add descriptions and looks nicer overall.
Here we go.
http://imgur.com/a/e2FQj