Hylux
12-01-2015, 08:13 PM
Hey guys was just wondering if anyone recommends any machining shops in Brisbane.
Was also wondering if people had ballpark figures for the following, just so I know I'm not getting ridiculously ripped off:
- Block decked
- Block bored and honed
- Valve seats machined
- Head resurfaced
Also does anyone recommend me do anything else? I am aiming for a minimal cost OEM rebuild for a car that's just going to be daily driven and never really pushed.
The engine is a B18C2.
Was also wondering if people had ballpark figures for the following, just so I know I'm not getting ridiculously ripped off:
- Block decked
- Block bored and honed
- Valve seats machined
- Head resurfaced
Also does anyone recommend me do anything else? I am aiming for a minimal cost OEM rebuild for a car that's just going to be daily driven and never really pushed.
The engine is a B18C2.