Dxs
09-04-2015, 12:44 PM
Hi all,
I am replacing my clutch and flywheel in an accord with an F22.
I tapped out the flywheel bearing of the OLD flywheel that which is made in USA.
When I put the bearing in the NEW made in china flywheel it is very loose. It just falls in with no resistance at all and a slight gap as pictured - so it can spin freely. The clutch tool I have fits snug on the bearing - so pulling the bearing apart wider would result in a poor fit I presume too.
http://i58.tinypic.com/xcq9p0.jpg
Is this flywheel bearing needed? I would say so because the gearbox shaft that goes through the clutch would run on the bearing right? So having a loose tolerance would be bad?
I am replacing my clutch and flywheel in an accord with an F22.
I tapped out the flywheel bearing of the OLD flywheel that which is made in USA.
When I put the bearing in the NEW made in china flywheel it is very loose. It just falls in with no resistance at all and a slight gap as pictured - so it can spin freely. The clutch tool I have fits snug on the bearing - so pulling the bearing apart wider would result in a poor fit I presume too.
http://i58.tinypic.com/xcq9p0.jpg
Is this flywheel bearing needed? I would say so because the gearbox shaft that goes through the clutch would run on the bearing right? So having a loose tolerance would be bad?