no vtec with hondata vtec with apexi?

[Shagwell]

Hey guys, i have just recently finished a 94 OBD1 b18c2 swap into my 99 ek1 hatch.
Using an ek4 harness.
Ive got a p28 chipped with hondata s300 ecu, also using a jumper from OBD2a - OBD1.
Now car runs fine, ive uploaded the jdm p72 base map on hondata. I get the o2 sensor fault and knock sensor fault. I disable both through hondata.
But vtec wont engage.
But when i go to use my apexi power fc ecu vtec engages perfectly fine..
So i know my wiring is correct..
Any help would be deeply appreciated.

Sent from my SM-N950F using Tapatalk

[ECU-MAN]

Check your VTS wiring from A4 of the ECU to the solenoid, ensure you have continuity, make sure the Apexi is not wired into the VTS in any way