How do you fix the damaged guard?

[merr.]

Hi guys,

what would be the best way to fix a damaged guard?

My left guard popped out. The screws had come off and the holes were damaged so it is impossible to replace the screw.

I tried to screw it back on and it worked for a bit until i put 16" rims on my EG and lowered it 2 inches.

The other guards don't rub against the tyres, but i haven't had a full car yet, so im not sure if it will.

I got king springs, stock shocks. It rides well, not very bouncy at all.

But now the damaged guard has popped out again. It only rubs on hard turns.

I was thinking of rolling back the guards. Will this fix the damage guard as well?

[mugeneration]

yeah sounds like you should roll the guards, but as to wether it would fix the original problem i dont know. after an incident i had i had to get the guard repaired by a plastics repairer (obviously lol). But if there's no damage to the actual plastic then you dont need to do this. perhaps get some new screws and get your guards rolled?

[merr.]

Just the hole for the screw was damaged which means i can't really put another screw into it. I might get the guard replaced, then i'll roll them back.

Thanks.

btw.. how much do u think it would cost to replace it?

[mugeneration]

oooooohhh to replace im not sure, but you could get it repaired, but even thats a tad expensive. Check with a wreckers, i mean its just a piece of plastic that gets flicked with mud and crap right? no reason to buy a NEW one.