ONV73C
28-07-2005, 12:39 PM
About a month ago i noticed my temp gauge was very low i.e the needle only just moving off C once the engine warmed and just reaching the start of the temprange. Also the heater wasn't working well... obviously my thermostat was shot!
Have replaced the thermostat and o ring, now the heater is working fine however the same prob continues with the temperature needle... it only just moves off C to the start of the range.
As i understand normal temp u should see the needle at around 1/4.
Any suggestions, ideas?
Have replaced the thermostat and o ring, now the heater is working fine however the same prob continues with the temperature needle... it only just moves off C to the start of the range.
As i understand normal temp u should see the needle at around 1/4.
Any suggestions, ideas?