PDA

View Full Version : Integ Tuning



Integ LS
16-02-2004, 01:27 PM
Does anyone now any good work shops in Melb to take the teg to its running Rich have replaced map Dizy still blows Black smoke on gear chngs.

vti-2
16-02-2004, 09:25 PM
Just some advice, i can see that you are a newbie. Do a search cause there are heaps of threads already that discuss workshops in Melbourne.

Just use keywords like 'workshops in Melbourne' and you will find a starting point. :)

poweredbyhonda
17-02-2004, 12:13 PM
What have you done to the car?
If it's stock have you tried resetting the ECU? If not take the ground wire off the battery for an hour and re hook it up. Should reset your settings and re adjust itself when you start driving.

BLKCRX
17-02-2004, 12:33 PM
If your car is stock... sounds like one of your sensors is playing up and causing the car to run "wrong" a programmable ecu won't fix this problem unless you replace all your sensors, along with a programmable ECU. The easiest way is to diagnose what’s wrong with your car replace the required sensors, which will result in everything returning to normal on your stock ECU, if your after performance gains, then look at a tuneable ECU.


Regards James

poid
17-02-2004, 12:56 PM
is the check engine light lit?

Integ LS
17-02-2004, 03:56 PM
All thats done is induction removed all piping from in the gaurd and run straight induction into airbox with K&N Pannel aswell as exhaust manifold back High flow cat, No
Engine light have replaced Map sensor checked Oxy sensor it is fine Error was showing map sensor.. I should try removing the earth so that it all resets...
Its a B18A1