removing side repeaters

[BIG`O]

just a general question, dont want to risk damaging the tegs to remove the side repeaters. i'm after some clears to replace the stock orange ones.
so my 2 questions are:
how do i remove the stock side repeaters?
what cars have clear repeaters that will fit existing holes?
(no, im not gonna go steal some. wreckers)
thanks heaps
BIG`O

[bennjamin]

you can shimmy in a flathead screwdriver to pop it out ( there is a small clip too holding it on) , and then remove the wire behind and install the new one in reverse order.

PM egSi on this forum , i believe he can get clear side indicators for your application.

[BIG`O]

byt the way its for a 1994 model GSi.

[euro1978]

if you wanna make sure you dont scratch your car.

get a cloth and wrap the head of the screwdriver in the cloth. Obviously you need a small screwdriver and a thin cloth but I found this to be the best way to prevent any scratching on your car.

Also don't let the wire loom fall back into the guard. (Its a bit of a pain to get it back out as I learned the hard way)

Good Luck with it.

[T-onedc2]

Yeah like Ben (edit: and the Hoff) said use a small flat blade screw driver to fit in the situated on one end of the indicator, push towards the centre and lift outwards. I placed a cloth against the panel to avoid and accidental scratches. '93+ Integras use same side indicators.

[BIG`O]

so what indicators will fit?
need to go to wreckers and grab some.

[T-onedc2]

so what indicators will fit?
need to go to wreckers and grab some.
You won't find em at a wrecker. I got mine form Motorware in Melbourne $45, but you can get em just about anywhere.

[blubber]

Where abouts are ya? There is a car shop in Melb next to Footscray train station that sells them, my mate got me some from there, they were bloody cheap!!

[medo]

you can get em off ebay

*edited out link bump*
:D

[Boy_Integra]

PM egSi on this forum , i believe he can get clear side indicators for your application.