View Full Version : EG civic breeze d13b valve clearance
Vtec_inside
14-09-2005, 07:27 AM
Anyone got the technical and how to do it yourself ? If so let me know. been searching online can't find the gap clearance from factory. Also can someone tell me how to do it on single cam.
ECU-MAN
14-09-2005, 11:17 PM
dude
search harder :) the answer is out there
http://www.ozhonda.com/forum/showthread.php?t=15443&highlight=tappets+DIY
http://b16a2.kicks-ass.net/automotive/honda/techguide/civic/93breeze+VEi_tech_guide.htm
1993 Breeze
V.I.N: JHMEG331
Engine: D13B2
Valve clearances (cold)
Inlet 0.18 - 0.22mm
Exhaust 0.23 - 0.27mm
at valve
Vtec_inside
15-09-2005, 02:05 PM
you guys are life saver thx man. ya did not search for tappets adjustment man . thx alot fot the info ECU MAN.
Vtec_inside
16-09-2005, 03:02 AM
ecu man if ur reading just curious valve clrance can be anything in between the figure given or ie inlet .18-.22 mm?
ECU-MAN
16-09-2005, 10:44 PM
yes,
I like to do them in the middle, more to tight side of things say for inlet
.19 or .20
Vtec_inside
17-09-2005, 02:39 PM
kool ya i have done my car it runs much better flat spot gone
Vtec_inside
20-09-2005, 11:07 PM
just a bump for the other trend regarding valve clarence .
DHOCHKG
22-09-2005, 04:10 PM
dude
search harder :) the answer is out there
http://www.ozhonda.com/forum/showthread.php?t=15443&highlight=tappets+DIY
http://b16a2.kicks-ass.net/automotive/honda/techguide/civic/93breeze+VEi_tech_guide.htm
1993 Breeze
V.I.N: JHMEG331
Engine: D13B2
Valve clearances (cold)
Inlet 0.18 - 0.22mm
Exhaust 0.23 - 0.27mm
at valve
Wat about a 93 Integra Vti-R?
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.