tightening my rear bumper

[nastyazn694u]

hey guys,
i just noticed that one side of the rear bumper of my ITR isn't 100% tight and flush with the corresponding rear panels. So i was wanting to tighten it up. I ahd a look around but i can't figure out how to access the screws/pins. can someone pleasehelp me. i'd appreciate it.
Cheers

[All_Motor]

To get access to the nuts you gotta remove the interior boot trim. You'll see about 4 or 5 nuts that hold the rear bumper to the car.

There's another another 2 screws at each end of where the wheel arch and the rear bumper meet and the last 2 nuts in the middle end of the rear bumper ( just kinda below where the rego plate goes).