Code 6 from ECU on an integra/not starting

[-unknown-sss]

Im currently experiencing a code 6 from the ECU as i attempt to start the 94 integra. Ive run up a search but only got an ECU code listing for a CIVIC in which states i have a water temp problem

Also the car is not starting as it has fuel pump issues at the moment. The PGMFI (Fuel relay fuse) has been replaced and no vital signs of fuel coming out of the fuel regulator. The fuel pump is priming. Ive done a thorough search but cannot come to a conclusion.

I have spark on all four leads (coils and ignition is good)
The starter motor is working fine (checked the + and - )
The alternator is giving out the right amount of volts (grounded)
The battery is working fine and new
All fuses have been checked from Cabin and bonnet.
I have replaced the fuel pump and pickup.
I have replaced the PGMFI relay and checked the soldering
I have REDS and it cranks but no fuel
I have checked the fuel lines for blocks and leaks
Fuel filter has been replaced.
Ive conducted the test from the ECU using a wire to connect the clips from underneath the passngr glove box.

It is emitting a code 6 beep, which is 6 single beeps.
Any suggestion is appreciated.

[[[d a n n y]]]

http://www.ozhonda.com/forum/showthread.php?t=8218

try there..

maybe your distributor.
that's what mine did when it had a dead dizzy sparks but no turn overs

[ECU-MAN]

dude. you have done so well to tell us what you have done and where you at
thanks.

the ECU never beebs. the beeps you hear are just seatbelt warning

do what danny mentioned above to test your ecu.

did you use the correct fuel pump. I have seen some pumps where the strainer dosnt sit the right way and wont catch fuel.